News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

A little help on how the dash mounts

Started by green69rt, March 12, 2017, 05:57:23 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

green69rt

March 12, 2017, 05:57:23 PM
I'm starting to work the dash and was test fitting it to the car.  I noticed that the side "flaps" sit on the outside of the door flanges.  See the picture below for the driver side.  Is this right?  I can't see it fitting any other way.  Kind of looks unfinished.  Is there some kind of molding that dresses it up?

cdr

#1
March 12, 2017, 06:13:08 PM
yes that is correct, also make sure you fit the dash,over the steering column studs 1st then roll the dash into position.
LINK TO MY STORY http://www.onallcylinders.com/2015/11/16/ride-shares-charlie-keel-battles-cancer-ms-to-build-brilliant-1968-dodge-charger/  
                                                                                           
68 Charger 512 cid,9.7to1,Hilborn EFI,Home ported 440 source heads,small hyd roller cam,COLD A/C ,,a518 trans,Dana 60 ,4.10 gear,10.93 et,4100lbs on street tires full exhaust daily driver
Charger55 by Charlie Keel, on Flickr

cdr

#2
March 12, 2017, 06:17:47 PM
1
LINK TO MY STORY http://www.onallcylinders.com/2015/11/16/ride-shares-charlie-keel-battles-cancer-ms-to-build-brilliant-1968-dodge-charger/  
                                                                                           
68 Charger 512 cid,9.7to1,Hilborn EFI,Home ported 440 source heads,small hyd roller cam,COLD A/C ,,a518 trans,Dana 60 ,4.10 gear,10.93 et,4100lbs on street tires full exhaust daily driver
Charger55 by Charlie Keel, on Flickr

green69rt

#3
March 12, 2017, 07:20:39 PM
Yeap, I had forgot about the steering column studs.  Fits better when they are in the holes properly. :slap:
Print
Go Up Pages1
User actions