How to bypass Neutral Safety Switch?

[rollo1504]

Hey guys!

As some of you might already know I am new here (and also new to my 73 charger) and actually working on the re-wiring of the car to fire it up...

I want to start the engine but have only the 8-pin bulkhead connected where all vital things are connected to start the car...

I am almost done but the question I have would be to know how I can bypass the neutral safety switch... I know this is not good as then cranking is possible without being in P or N but I am trustworthy.... :-)

So... Will I have to connect a wire to somewhere starting from the starter relay? I dont have the 4-pin bulkhead connector installed... Thats why I am asking if I can make a workaround starting directly from the starter relay....
Can anybody give me a hint?

Thanks folks

Roland

[Nacho-RT74]

Ground to chassis the G terminar at starter relay... just a jumper wire with chassis and done

[rollo1504]

Ground to chassis the G terminar at starter relay... just a jumper wire with chassis and done

I already assumed that after reading the wiring diagram but just wanted to be sure

Thank you

Roland

[Bronzedodge]

Be extremely careful.  I bypassed the switch in my Demon way back when, 28 years ago.  My dog knocked the car into gear - my fault, sticky gate on the console shifter.  Nearly took out an adjacent car.

[A383Wing]

I am almost done but the question I have would be to know how I can bypass the neutral safety switch... I know this is not good as then cranking is possible without being in P or N but I am trustworthy.... :-)

Be sure to post pictures of the aftermath when you forget to take the car out of drive or reverse when you go to start it, you know you will forget at least once

[rollo1504]

I will.... I have already ordered a neutral safety switch and I will do the correct wiring as soon as possible....

Its just that for being able to start the car and open the next "mysterious" chapter..... The ignition timing :-) ...questions will follow 

But thank you guys for being concerned about a Charger newbie....

I appreciate that

Roland