Finding 70' Charger rear window weatherstrip

[tommyhr]

I am going to replace the vinyl top, but have not been able to find the rear window weatherstrip anywhere online. Has anyone had any luck doing so?

     

[BLK 68 R/T]

There is no weatherstrip. Rear window is held in with a ribbon tape.

[JR]

Yup. Sold at most parts stores. Ribbon tape with two plastic blocks to locate the window.

[tommyhr]

thanks guys

[BLK 68 R/T]

Just make sure you get the right size. I cannot remember which size is needed, 5/16" or 3/8"? if you get the wrong size the widow will either sit too low or too high, causing the trim to not fit properly.

[tan top]

Just make sure you get the right size. I cannot remember which size is needed, 5/16" or 3/8"? if you get the wrong size the widow will either sit too low or too high, causing the trim to not fit properly.

 
if your rear glass channel is 100% factory dimensions  , then you need the 5/16ths  ,

[Wingnut426]

I believe its called Butyle Tape?   Make sure whomever is putting the rear glass in doesn't put it in upside down! Happened to me once!

[ACUDANUT]

I believe its called Butyle Tape?   Make sure whomever is putting the rear glass in doesn't put it in upside down! Happened to me once!

Upside down ? It would never fit.
It can be installed...Wrong side out.  

[DAY CLONA]

Just make sure you get the right size. I cannot remember which size is needed, 5/16" or 3/8"? if you get the wrong size the widow will either sit too low or too high, causing the trim to not fit properly.

 
if your rear glass channel is 100% factory dimensions  , then you need the 5/16ths  ,

I usually find the 5/16 is ideal for the Charger rear window, but always best to have both 5/16 and 3/8 on hand "just in case", as you know the parts stores are always closd, or out of stock when you need it NOW!