Bright light foot switch

[J-440]

Got a 68 with the stock foot dimmer switch and my high beams stay on, even when I press the switch.  Only 3 wires come from this thing.  I know the red wire goes to brights, violet to lows, and green goes to the dash switch.  I did the headlight relay conversion from this site since I have aftermarket xenon bulbs and halos.  I did however wire my lights to ALL come on at once, even the lower driving lights.  I just liked the look. 
  Wondering if this would be the cause as to why my low beams won't come on?  Thanks again.

[J-440]

 Sheesh....what's it called when you don't spend enough time to figure out the problem and you immediately want an answer right away?  Impatience!!  I figured the problem out 2 minutes after I typed this. 
  There needs to be an "Erase message button" for people like me.  Thanks again guys. 

[Nacho-RT74]

of course... because high beams doesn't have the low beam function, so if you did what I think somehow you are getting a "feedback" splicing power everywhere no matter where it comes the source, low or high beams at footswitch.

UNLESS you install low/high beams bulbs also on high beams location to get both setups on all 4 beams. Will need of course add extra wiring to the inner bulbs to feed the lows separatelly from the highs on them

[John_Kunkel]

There needs to be an "Erase message button" for people like me.  

Just hit the Modify button, erase the text and replace it with POST DELETED.

[M5Ivan]

Sheesh....what's it called when you don't spend enough time to figure out the problem and you immediately want an answer right away?  Impatience!!  I figured the problem out 2 minutes after I typed this. 
  There needs to be an "Erase message button" for people like me.  Thanks again guys. 

Done that a few times