Twin hood scoop location

[remta1]

Hi can someone help me by running a tape measure over the the back and side measurements of
The scoop locations on the hood
It is a 70 coronet but 69 and 68 hoods will be fine

I need to know how far from the back edge and to the side edge of the scoops , I can work out the hole drilling measurements from there 
Cheers
Jase

[Alaskan_TA]

Some of the hoods have some of the holes pre-punched in the under side skin, does your hood have them?

[lukedukem]

One of these hoods, this came with my 69 super bee

Luke

[lukedukem]

Here are some measurements, if you need more I can run out to my shop later
A: 2 1/8"
B: 3 1/2"
C: 4 7/8"
D: 13 1/2"

Remember that B & C deal with curves of the scoop and hood, but I tried to get them best I could. The black lines on the picture is exactly where I put the tape measure. And on A & D, I took the measurement off the tip of the chrome trim.

Luke

[birdsandbees]

Luke.. get that hood off it's "ears" and onto it's side.

[lukedukem]

Luke.. get that hood off it's "ears" and onto it's side.

Got it. 

Luke

[remta1]

Awesome exactly what I needed , thanks for going to the time and trouble to do this

[lukedukem]

Awesome exactly what I needed , thanks for going to the time and trouble to do this

No problem. 

Luke