building a chassis support for a 1968 charger, in need of some advice?

[under construction]

I have a 1968 charger that needs full front floor plan replacement,  cross member, trunk floor, and possibly rear frame rails and inner rockers. I know I need to build a jig to support the car and make sure nothing move a out of alignment.

Does anyone have any references or input on fabricating this type of structure, gage tubing to use, etc? I'm kinda at a sticking point over this. I'm a good welder, pipewelder by trade. I just need pointed in the right direction by someone with a lot more experience than myself.

[under construction]

I have a 1968 charger that needs full front floor plan replacement,  cross member, trunk floor, and possibly rear frame rails and inner rockers. I know I need to build a jig to support the car and make sure nothing moves out of alignment. 

Does anyone have any references or input on fabricating this type of structure, gage tubing to use, etc? I'm kinda at a sticking point over this. I'm a good welder, pipewelder by trade. I just need pointed in the right direction by someone with a lot more experience than myself

[under construction]

I have a 1968 charger that needs full front floor plan replacement,  cross member, trunk floor, and possibly rear frame rails and inner rockers. I know I need to build a jig to support the car and make sure nothing moves out of alignment. 

Does anyone have any references or input on fabricating this type of structure, gage tubing to use, etc? I'm kinda at a sticking point over this. I'm a good welder, pipewelder by trade. I just need pointed in the right direction by someone with a lot more experience than myself

[Aussiemadonmopars]

Maybe have a chat to Don:

http://www.dodgecharger.com/forum/index.php/topic,104414.0.html

[lukedukem]

http://www.dodgecharger.com/forum/index.php/topic,126547.msg1572732/boardseen.html#new

Luke

[birdsandbees]

How the shop did mine...entire floor from firewall to rear bumper, wheel wells, right front rail, both rears and trans x member.

[Lennard]

I have a 1968 charger that needs full front floor plan replacement,  cross member, trunk floor, and possibly rear frame rails and inner rockers. I know I need to build a jig to support the car and make sure nothing moves out of alignment. 

Does anyone have any references or input on fabricating this type of structure, gage tubing to use, etc? I'm kinda at a sticking point over this. I'm a good welder, pipewelder by trade. I just need pointed in the right direction by someone with a lot more experience than myself

You posted the same question in three different forum sections. 

[Highbanked Hauler]

 WOW, yes I would say you have it braced up.