Plastic Cover - Where does it go?

[john108]

1968 Dodge Charger.  I had this plastic cover in a box with all the under dash ducting.
Does it somehow fit under the Dash Assembly?  And where?  OR Where?
Thank You,
John

[A383Wing]

under right side of dash...it's to cover the AC stuff under there

[john108]

Thank you, a few more questions, please.

I have the dash assembly on a table.
The attached picture shows where I believe you instructed me to look.
The holes in the dash are small and I probably would have missed them.
What do the screws look like, are they simple sheet metal screws?

What goes through the larger elongated hole?

[A383Wing]

yes, they are larger than normal sheet metal screws, with washers...3 of them to the dash frame.....and I think another to the larger one at the bottom...that attaches to the heater box if I remember

[Charger-Bodie]

Should be a stud on the bottom of the heater-a/c box.

[john108]

Finding the right screws may be a challenge.  the 3 holes in the dash frame are small and the screws probably need to be short.
Washers should be easy.

And, YES, There is a stud near the corner of the heater A/C Box.
I would have found it during assembly, but not easy just looking at the parts.

[PlainfieldCharger]

This is what I used to install the cover to the dash...

http://www.rtspecialties.net/proddetail.asp?prod=1000934

[john108]

Plainfield...
The 10-24 screw is .190 diameter.
The holes in the dash frame are less than half that.
I think it requires a sheet metal screw unless the holes were drilled out.
Thank you