Accessory wire/signal splitting from ignition switch

[raybork]

I"m installing a Dakota Digital cluster and a Redondo radio in my 68 Charger. Both require the accessory wire/signal from the ignition switch. I only have one wire that provides that. Any suggestions on how I could/should split that wire/signal for both items?

Thanks

[Just 6T9 CHGR]

How about a dual wire tap?

[John_Kunkel]

In some years the accessory terminal in the fuse box will have stackable spade terminals similar to the pic below but without the blue insulator.

[raybork]

Thanks for the help!

[b5blue]

I use this and it works very well:  http://www.lowes.com/pd/Alumiconn-2-Pack-Plastic-Standard-Wire-Connector/4433877?cm_mmc=SCE_PLA-_-RoughPlumbingElectrical-_-ElectricalAccessories-_-4433877:Alumiconn&CAWELAID=&kpid=4433877&CAGPSPN=pla&store_code=1190&k_clickID=1df88053-5631-4d4c-a2d4-51b69184d2f3

[b5blue]

Check the spec. here:  http://www.kinginnovation.com/products/20/3-port-alumiconn

[john108]

My 68 Charger fuse block uses many of the stackable terminals that John Kunkel showed, and it is original.