Rear glass corner patch

[Silver R/T]

Is this correct patch for rusted out corners where window sits in?
http://www.ebay.com/itm/390806570978?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

[keepat]

Not for a charger, looks like a road runner  and GTX part
Pat

[Silver R/T]

Anyone knows where I can get one for Charger?

[Pat1973charger]

You will have to find a donor or fabricate them.

[BLK 68 R/T]

Here are 2 parts that will get you what you need I think. Did not have any luck finding just the small patch panels.

https://www.yearone.com/Product/chrysler-b-body/mx39lhrh
https://www.yearone.com/Product/chrysler-b-body/df687

[GMP440]

Not to hijack this thread; but, I used that corner piece on my 68' Coronet.  Very well made piece.  The side and bottom chrome moulding
pieces fit perfectly to it.  It even matched up with the roof and dutchman sections on the Coronet perfectly.

[twenty mike mike]

Here are 2 parts that will get you what you need I think. Did not have any luck finding just the small patch panels.

https://www.yearone.com/Product/chrysler-b-body/mx39lhrh
https://www.yearone.com/Product/chrysler-b-body/df687

Exactly. I just went through this. The shop installed the entire Dutchman panel, but grafted in a piece of the sailpanel. If you need just the corners repaired, you'll still have to get either the three new pieces, or find a donor. Since those corners are probably the first places on the car to rust, good luck with that.

I got the sailpanels from Rock Auto at about 75% of everyone else's price.

The latest Classic catalog advertises corner pieces that will "fit all B Bodies," but that is wrong, wrong, wrong.

[green69rt]

Is this correct patch for rusted out corners where window sits in?
http://www.ebay.com/itm/390806570978?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Look on AMD site, it specifies this piece for B-bodies EXCEPT Charger.

http://www.autometaldirect.com/amd-68-70-b-body-except-charger-deck-filler-outside-patch---rh-p-4704.html

Since this is a Charger site I assumed you need it for a Charger.

[NickJ]

I had this exact same problem (Don't we all!) and Goodmark makes a patch piece for that section but it seems to always be on backorder. After a couple months of waiting I ordered a shrinker/stretcher combo from Eastwood for about the same amount of money as a single patch panel. I'm no master fabricator but it really wasn't hard at all to make new corners for the Charger. Give it a try.. You may surprise yourself! Good Luck!

Nick