moog o/s uca bushing info wanted

[poppa]

Hey ,

Thinking of trying the Moog offset upper control arm bushings. Questions -
a) are these pressed in?
b) do I have  to replace the front and back ones on each side or just one on each side???
c) anyone try these? What do you think of them?
Thanks

[303 Mopar]

a. yes
b. both front and back on each side
c. love them, would recommend to anyone who has stock UCA.

[Lennard]

A: Yes, pressed in.

B:Two on each side.

C: I have them but my car is years away from alignment.

Edit, late again.

[b5blue]

They can be installed stagger to change castor also. 

[poppa]

Are they pretty much set , install front one closer to outside and rear one closer to inside or are you doing a hit n miss type install? Thanks for the quick replies!

[303 Mopar]

Are they pretty much set , install front one closer to outside and rear one closer to inside or are you doing a hit n miss type install? Thanks for the quick replies!

[b5blue]

I installed that  way on new repop UCA's. 

[Lennard]

I installed that  way on new repop UCA's. 

Yeah,  I used that diagram as well.

[poppa]

So , fronts all the way out (toward fender) , rears all the way in (towards frame).??

[b5blue]

http://www.hotrodhotline.com/md/html/caster.php

[HPP]

So , fronts all the way out (toward fender) , rears all the way in (towards frame).??

Yes. Then do the same with the adjustment eccentrics. Measure. If more + camber is needed at that point, rotate the front eccentric to bring camber up to -1* or so. Stop.

[John_Kunkel]

So , fronts all the way out (toward fender) , rears all the way in (towards frame).??

I think it depends on how much you want to change the caster, for a minor correction only one offset bushing might be required.

[poppa]

So , fronts all the way out (toward fender) , rears all the way in (towards frame).??

I think it depends on how much you want to change the caster, for a minor correction only one offset bushing might be required.

I was thinking this. But , I think I need at least the 4 everyone has been suggesting. I'll know when I get these bushings and take it in. I am sure they set mine to factory.

[HPP]

Can't get enough positive caster in these heaps. Use em both. Camber is easy and can be added with hardened washers under the spindle bolts if necessary.