Blower motor seal gen II

[Calif240]

Anyone know where to locate the rubber seal that goes between the two blower motor plates and surrounds the blower motor on a '69 charger? This is a rubber seal that has three holes for the mount at 0, 120 and 240 degrees. I can't seem to find anywhere.
Thanks!
Terry

[BLK 68 R/T]

There was a thread on this a few months ago, I think the consensus was good used or repair what you have are the only options. Currently not reproduced.

[birdsandbees]

This was the one I was looking for earlier this month... doesn't seem to be reproduced. Found one from a Ford Restoration company that was very close and probably would have worked, but I was able to fix mine well enough to just reuse it.