Help ID these bolts

[68ChargerJMP]

I have been recently trying to sort through all of the hardware that has been sitting in bags and boxes for years. Unfortunately some didn't get bagged and tagged as thoroughly as I was hoping and I have ran across many fasteners that I have no clue about. I will probably end up getting a copy of the B-body fasteners guide eventually, but can anyone help ID these bolts: The first bag is marked steering/brake misc. (maybe the pedal brace rod bolts/nuts???) I found another bag that had the column mount bolts, column plate to firewall bolts, so I don't think they go with that portion.
The second bag was not marked at all, but looks like it would could maybe go to the front bumper brackets??? Thanks guys.

[tan top]

 been 15/ 16ish years since I striped my charger down & done a complete nut & bolt resto , I've long since , forgotten loads of stuff   , its hard to judge the scale  in your pictures , there are a lot on our chargers that look the  almost the same , but are different sizes etc .
have a look at the pictures & stuff below  , it may give you some idea &  point you in the right direction ,


A & B  could be fender bolts & lower valance to core support hardware , like a mentioned , had to tell from picture the scale

[tan top]

 

[tan top]

 

[68ChargerJMP]

Thanks tan top...I can see this is gonna be a very tough part of the build back.
The fact that there is nothing in the bag that was marked steering/pedals etc.., goes to any of the steering or pedal components, makes me a little concerned of all the other labeled bags...
I knew the carriage bolts didn't go on the exterior of either bumper because they are too big and as you mentioned, no stainless caps. Everywhere I have seen the rear bracket bolts, they were just like the ones in your pic, hex head not carriage.

[tan top]

 yeah can be time consuming looking through stuff & trying to figure out what goes where  ,  when someone else has done it    ,  its can be bad enough , when you have done it your self &  labled bagged it up 3 or 4 years before    ask me how I know , only happened once though  



 post up any pictures etc with things your not sure of , & we will all help if we can .

what stage are you at with your charger ? was it a total nut & bolt rebuild or ....





  i'll  take a few pictures  of my  bumper attaching hardware  later , ( mine still had all the original bolts & stuff ) & post here .

[68ChargerJMP]

I wish it had only been 3 or 4 years....more like 20-25. I hate to even admit it, but I started tearing it down in 1990....Yeah, its a complete nut and bolt resto. I have it on a rotisserie at the moment trying to wrap up some underneath stuff. Hopefully, I will be getting it down from there around Springtime next year and really start rolling along. I have been restoring all the small stuff lately (pedals, cluster, column, heater box, etc...). That way, when I get to that point, said part will be ready to be installed.

[tan top]

  took these of mine  , bolts & etc are the original to the car , although not the correct color / type of plating .  they don't show much , but may be of some use ! 

[tan top]