Where to hide the wires

[comet_666]

Hey guys, going to be running a Firecore RTR and a 1 wire alt on my ride. Anyone else doing this? If so, what did you all do with the wiring for the elect ignition module, ballest and regulator?

[b5blue]

I joined start and run under the dash and connected run to a control relay that turns on power to the coil/dizzy. Then I removed all unused wire and devices.

[Back N Black]

I wanted mine to look stock, so i modified the ballast resistor with a solid wire and used a dummy plug for the orange box. The original wires i taped up and tucked in on the fire wall out of sight.  

[Dino]

I got rid of my ballast resistor and wiring.  I connected start and run under the dash and ran it to the bulkhead connector.  From there a new beefy single wire runs to the coil.

[303 Mopar]

You will want to tie the start and run wires together, get rid of the ballast resistor since they go our often anyway and you do not need it.  I ran all my wires in a loom between the intake and valve cover.

[comet_666]

Which are the start and run wires?

[303 Mopar]

Which are the start and run wires?

Stock is blue and brown.  Get a volt meter on each and have someone put the key in the on position and then crank the car and the correct wires should show 12v in each positions.