'68 Blower motor rubber gasket?

[MxRacer855]

Does anyone know where to find one?

I've looked everywhere! 

It's that gasket with two rubber grommets 180 degrees apart that seals the blower motor to the panel.

Thanks

Jeff

[BLK 68 R/T]

Anything in the below picture look like the right part? I'm assuming it's for an a/c car? since I don't recall any rubber gaskets with grommets to mount the blower motor on a non a/c car.

[MxRacer855]

Nothing looks familiar in that pic. 
It's actually a non A/C car!

When I get home from work I'll take a pic and post it.

Thanks
Jeff

[Moparparts]

I have one, not perfect but servicable. PM or E-Mail me if interested

[oldcarnut]

Either look familiar?

[MxRacer855]

Sounds good MoparParts! Will do!

Carguy, yes! It is the one on the top pic where the three nuts rest on.

Jeff

[nascarxx29]

http://ac-blower-motor.dvautoparts.com/discount-store/dmt-mopar-66-70-b-body-ac-a-c-w-krjjkmoriono

[MxRacer855]

It's different than that. I've tried posting a pic of it like 10 times... 
Standby, I'm determined to get it.

Thanks

Jeff

[oldcarnut]

Carguy, yes! It is the one on the top pic where the three nuts rest on.

Jeff

That s the fan for AC If you dont find one let me know and I'll part anything on it out. 

[nascarxx29]

http://www.autopartsdb.net/assets/images/ProductImg/M/MA4810.JPG

[tan top]

 you did say non A/C blower motor ?  ( Standard heater box  ) the only  rubber  gasket they have is this , below ! see green arrow

not seen them reproduced  anywhere   


http://www.smsmopar.com/default.html

[MxRacer855]

That's it Tan Top!!!!

Someone needs to reproduce these!

[tan top]

That's it Tan Top!!!!

Someone needs to reproduce these!

  yeah  , they should , & the four metal washer / spacer  shim type things  ,  when I swapped out my AC heaterbox  late last year for a standard non ac heaterbox set  up , found that gasket on the box I had was very brittle & hard ,  & just starting to split , we'll crack in places   , how I removed  mine from the heaterbox metal back plate , was to warm it up with a hot air gun a little & then give it a squirt of wd40 where it slides !  as you have to bend it to remove it ! fitting it the same procedure !    before I refitted mine  , used windshield glue / sikaflex , for bonded in windshields ,  stick any splits together & coat each sides of the rubber , with said product !  effectively making a new skin , leave it to cure , best give it a couple of days just to make sure , other wise your never get the motor off , with out bending up the heaterbox back plate , just be on the safe side  , I  coat both sides of gasket with wd40,  stop any chance of it sticking  ,