Hood blinker wiring

[68charger383]

I need to replace the wire from the junction block to the male connecter wire on the hood signal assembly.

Basically, i installed a new hood blinker assembly and wire with a male end. There is a wire with a female plug which this new wire plugs into. The wire then goes into a white clip near the junction block.

Does anyone make/repop this part of the wiring harness/ Can I make it myself?

Here one I found but not sure if its the part I need from http://www.krusinmoons.homestead.com/reproductionproducts.html


Turn Signal Indicator Wires Used on 60's and early 70's Mopars. Wire can be ordered complete or with the crimped bullet end separate.  If ordered separate , crimped bullet end and heat shrink can be installed once wire is inserted into indicator. Custom Fit for your car.  $30.00/set+S/H

[Nacho-RT74]

you can make it by yourself, but ANYWAY just in case, chargerspecialties carries them... and they are on speciall offer now for members ( check General discussion sticked threads ).

[mopar0166]

nice find on that site, ive been looking for just the wire for my hood turn signals for a while

good stuff 

[el dub]

 Where is the wire that plugs into the turn signal wires coming out of the hood?

[HANDM]

Where is the wire that plugs into the turn signal wires coming out of the hood?

In the harness above the brake booster. It's a two blade female I think

[el dub]

Thanks for that.

[Just 6T9 CHGR]

Where is the wire that plugs into the turn signal wires coming out of the hood?

Part of the forward light harness.....lower plug on bulk head connector

[el dub]

Hey thanks for the pic.

[darkfiire5000]

Where did you get your new junction block for your new wiring?

[Nacho-RT74]

several vendors got them... You can search on ebay, but check MEGAPARTSUSA website. Nice prices and shipping charges