News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Little help reading this please

Started by timmycharger, June 01, 2015, 06:45:25 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

timmycharger

June 01, 2015, 06:45:25 PM
Ill admit, I have trouble reading these dial gauges, but I need a measurement for tomorrow as I need to order a bellhousing alignment tool. They need the crank flange register for my 440, I measured both the outside diameter of the flywheel register flange as well as the inside diameter of the hole in the flywheel and got the number on the dial pictured below. What the heck does this read? I was able to read my bellhousing bore (4.805) but not sure on this one.  Appreciate any help  :bow:

cdr

#1
June 01, 2015, 07:04:05 PM
2.150
LINK TO MY STORY http://www.onallcylinders.com/2015/11/16/ride-shares-charlie-keel-battles-cancer-ms-to-build-brilliant-1968-dodge-charger/  
                                                                                           
68 Charger 512 cid,9.7to1,Hilborn EFI,Home ported 440 source heads,small hyd roller cam,COLD A/C ,,a518 trans,Dana 60 ,4.10 gear,10.93 et,4100lbs on street tires full exhaust daily driver
Charger55 by Charlie Keel, on Flickr

A383Wing

#2
June 01, 2015, 07:24:02 PM
:iagree:

timmycharger

#3
June 01, 2015, 07:46:51 PM
Thank you gentlemen  :cheers:
Print
Go Up Pages1
User actions