door belt moulding clips GOOD guy alert !!

[cdr]

I know this will get moved, but this post might get a response from here  

thanks for the picture SHAKEY
i need this clip & the one next , it is a push in style, so i need one that has a nut & one pushes in, this is on top of the door for the chrome belt moulding.

thanks
charlie

[cdr]

 

[keepat]

Have you checked with RT specialties? The one in your picture would be easy to make if you can't find one.
Good luck!
Pat

http://www.rtspecialties.net/search.asp

[tan top]

  like Keepat said    , the end one wont be that difficult to make   ,   as for the others   not seen them any where ,  as a set ,    there are six I think from memory in total  , plus the very end one  , in your picture ,  all different  sizes ,   starting from the back of door , largest  to front smallest ,  they look like  this I think  , in the picture below ,  been years since I cleaned all mine up  

think  FA174  or 178 are the closest  ,  , with a piece of sealer ,  no idea on the sizes though   , will need to test  each one in your belt moulding  , to hole in door top , maybe   others on that page will work  


https://mrgusa.com/fasteners/

[Shakey]

Good Day,

Do some more searching for some more photos I posted.  I know I did a thread about stainless steel fasteners or something like that and had included numerous photos and part numbers.  If I find it, I'll bump it so perhaps it will help some others.  It was a while ago.  

Found it:  http://www.dodgecharger.com/forum/index.php/topic,23879.0.html

[cdr]

thanks everyone, but it would seem that no one has these, i will keep looking.

[ODZKing]

I have had very good luck with Altha Fasteners.  They have an EBay store as well.  Prices are not bad considering.
http://stores.ebay.com/althafastener/

[cdr]

I have had very good luck with Altha Fasteners.  They have an EBay store as well.  Prices are not bad considering.
http://stores.ebay.com/althafastener/

thanks odz ! i will check them out 

[green69rt]

Also, did you try these guys.  Hard to navigate their PDF catalog but they have a ton of trim fasteners.  Maybe just give them a call.
http://www.restorationspecialties.com/Catalog-PDF.html

[Shakey]

I did buy a pair of these from someone, can't recall if it was RT Specialties or Restoration Specialties, way back when and they were not wide enough.

It'd be worth it to try and track down who has them and ask for a measurement.

[70gtx440dana]

I know this will get moved, but this post might get a response from here 

thanks for the picture SHAKEY
i need this clip & the one next , it is a push in style, so i need one that has a nut & one pushes in, this is on top of the door for the chrome belt moulding.

thanks
charlie

Email me at: jsawyer@wowway.com  I have a couple of doors I can strip down and get these clips for you.

Just need some more details from you in regard to how many you need.    Joe

[cdr]

thanks to Joe  70gtx440dana   for the clips on the way !!!!!!!!!!      

[cdr]

Thanks again JOE !!!

JOE sent them to me at no cost, very cool !!!!! & they are correct!!!

   

[Lennard]

 

[VegasCharger]

X2

[tan top]

X2

  X3      ,   good stuff

[303 Mopar]

X2

  X3      ,   good stuff

x4     I love it when guys help each other out!