69 CHARGER MEASUREMENT

[sardillim]

I'm hoping someone has the interior out of their car and can measure the distance from the top of the inner 1/4 panel at the lock pillar to the same place on the opposite side.  If possible please respond with a photo so I can see exactly were the measurement was taken   

Thanks  Mike

[Mike DC]

I just stretched a tape measure from the inner-wall-to-inner-wall inside the quarters area, several inches back from the rear doorjambs.  All the interior is out and it's just raw unibody sheetmetal.

See the quarter window crank hole?  Look right above it.  There's a rectangular hole, above and slightly towards the rear of the car.  I put the tape measure on the bottom edges of that rectangular hole on both sides.  My car is just over 59" across there.

[garner7555]

First is the top of pinch weld in back of door jam.

Second is a few inches lower where there is a notch. 

Both are with the tape measure butted against the other side, not hooked over it. 

[garner7555]

The pictures to go with that will not post.  Send me an email address and I will send pictures