Gas pedal roller charger 1969

[charger-project.com]

Hi all,

I'am installing my gaspedal to the floor of my 69 charger, but I am missing the roller under the pedal. Can someone send me some (pics of the) dimensions of this roller thing.
Does it have a bearing or metal base in the middle? is it rubber, nylon, metal? because then i can start milling this thing like original.

Thanks so far!

[tan top]

its hard plastic / nylon   ,  made out the same stuff the heater control buttons  are made out of ,   no  metal sleeve or bearings

from where it goes down to 1/4  from 5/16 there is a bout a 3/64 ish " chanfer   counter sunk , both sides  , not sure of the correct word    I would just forget that bit &  just counter sink it both sides with a suitable drill bit

[tan top]

 

[charger-project.com]

Thank you so much, this is exactly all what i needed to know, to create one or more! thanks!

[myk]

There's a roller for the gas pedal?  I didn't know that lol; my car never had one...

[cdr]

that way you can rolllll into the throttle 

[tan top]

There's a roller for the gas pedal?  I didn't know that lol; my car never had one...

have a look here

ref 14 -11-39  , there is a small washer & R clip too

[cdr]

great picture TAN TOP,,, is that a 2 barrel or 4 barrel roller.

[tan top]

great picture TAN TOP,,, is that a 2 barrel or 4 barrel roller.

 all B-Bodies from 66 - 70  had the same set up  , well Deffo from 68 -70  

few more pictures from 69 parts book

[gtx6970]

readily avail

http://www.megapartsusa.com/proddetail.asp?prod=102%2DGPR

[tan top]

readily avail

http://www.megapartsusa.com/proddetail.asp?prod=102%2DGPR

   that one has a metal insert 

[ALBSURE1091]

I just used a bearing from an old skate wheel.
Works perfect & it was free.

[Donks01]

Anyone use an aftermarket gas pedal setup?