1969 Dodge Charger Power Window Harness Secure Points

[69RTSE]

Does anyone have pictures of how the power window harness is retained/secured to the floor boards.  I believe there are up to 6 wire looms/retainers.  Thanks.

[Mytur Binsdirti]

This is the only picture I have of mine......

[moparnation74]

This is the only picture I have of mine......

4spd, hemi, and power windows: Awesome!

[69RTSE]

Thanks for the picture.  Is there just the two wire looms/retainers that are visible or are there additional retainers towards the edges/rockers.  Thanks.

[VegasCharger]

As Turbin's pic shows there are the two floor mounts. There are two other floor mounts towards the rockers as you asked. Then they go into the rocker panel wire looms. There are not any additional secure points after that. The fronts run up the A-Pillars to the exiting rubber grommets and the rear wire harness runs just exit the metal loom. The rear pw switch wire looms just goes up on the outside of the quarter shell to the switch on the interior panels. The rear pw motor looms enter at the bottom of the shell thru the bottom slot and into the shell to the motor. What I'm not sure of if there's a mounting point inside of the quarter to prevent the wires from moving freely. Pics are attached.

[VegasCharger]

more pics..........

[Mytur Binsdirti]

4spd, hemi, and power windows: Awesome!

Yup, it's got all the power goodies, except for a radio. Go figure.