Bearing in steering column

[tan top]

 not been able to find a staple picture either  , but have altered a picture off the internet below !  staple is the grey line  

[keith88]

Thanks for the illustration hard to believe that that stops it from spinning. 

[clemul]

Staple is not to keep isolator from spinning. It is a ground for the horn and if you leave it out your horn will not work.

[keith88]

I don't have it and the horn works fine. And i cant see where it would stop it from spinning either there is no pressure on it to spin it spins on the bearing not on the outside insulator piece.

[clemul]

http://www.hamtramck-historical.com/images/TSBs/1967/D67-19-4%20p1.jpg

http://www.hamtramck-historical.com/images/TSBs/1967/D67-19-4%20p2.jpg

[keith88]

OK proved your point ..but i still don't have it,matter of fact i don't even have the insulator in place i used a section of old flat phone cord to fill the gap and the horn works fine.

[Nacho-RT74]

Staple is not to keep isolator from spinning. It is a ground for the horn and if you leave it out your horn will not work.

http://www.hamtramck-historical.com/images/TSBs/1967/D67-19-4%20p1.jpg

http://www.hamtramck-historical.com/images/TSBs/1967/D67-19-4%20p2.jpg

Damn really interesting!!!

[tan top]

Staple is not to keep isolator from spinning. It is a ground for the horn and if you leave it out your horn will not work.

http://www.hamtramck-historical.com/images/TSBs/1967/D67-19-4%20p1.jpg

http://www.hamtramck-historical.com/images/TSBs/1967/D67-19-4%20p2.jpg

Damn really interesting!!!

   
good find     interesting     !  

thinking now , where I read it about to stop the rubber insulator / bushing  spinning