Distribution block disc/disc

[lasvegas69charg]

Does anyone have a pic what a disc/disc looks like. I just want to make sure I got the right one.
This is the one I have:
https://www.yearone.com/Product/chrysler-b-body/dtb7

[lasvegas69charg]

Does anyone know if this is the right one?

[Ghoste]

It looks like it, well its for disc/drum anyway.  There isn't really one for disc/disc in these cars but the only thing that might be affected by that is the safety switch and I'm not sure about that at all.

[will]

I have the one from fine lines. Similar to the one you have, I'll get a pic when I climb under there on thursday.

[lasvegas69charg]

Ok I just want to make sure because they offer this one also and yearone couldn't help which one to use

https://www.yearone.com/Product/chrysler-b-body/dtb2

[Mopar Nut]

Ok I just want to make sure because they offer this one also and yearone couldn't help which one to use

https://www.yearone.com/Product/chrysler-b-body/dtb2

If you decide to go with YearOne's, they should have a 30% off on Labor Day weekend.

[Ghoste]

http://inlinetube.com/Prop%20Valves/BLK244.htm

http://inlinetube.com/Prop%20Valves/pro_valves.htm

[fy469rtse]

That's the set ghoste, those three valves are for power assist front disk brakes
Large one is the distribution block , the smaller one on bracket attached is the front lines proportion valve ,
The small independent one is the hold off valve for rear brakes ,
If your car was an early build car , it didn't have the proportion valve , just distribution valve and rear one,
A couple of threads on here with photo's showing the routing of brake lines ,
That rear hold off valve, I like to replace that with willwood adjustable valve , to help with brake bias ! Or to stop rears locking up first
I just did all of mine not long ago 

[Nacho-RT74]

I hope SOMEDAY this will be a quality product!

[dangina]

are you running discs all around? Don't bother with the stock setups that you have to gut, all you need is this:

http://www.themustangshop.ca/product/9481180/300917

[fy469rtse]

Dang, I don't shop at a ford mustang shop lol, prefer to put it all back as stock looking , only modify internals to engine and trans , even though mines what you would call a resto mod ,