Bolt/screw size chart

[Dino]

Is there such a thing for these old beasts?  I need to get some new bolts and a chart would come in real handy.

[Ghoste]

There is a fastener book available but it isn't cheap.  ICCA sells it?  I have a copy Dino so I'll help you where I can. 

[ODZKing]

Each parts book has a page or two with pics and sizes, is that what you mean?

[Dino]

I had no clue there was an entire book, not sure if I want to spend $115 right now but this may be invaluable come resto time.  I swear there are no two alike screws in my entire dash.  

Bob I just want to know which bolts are supposed to go here because over time they have been replaced with other stuff.  For instance, there's 4 different bolts, albeit with same threads, holding the radiator to the support.  They all have a slightly different head and different washers and different body length.  Even if I can't get originals right now, I figured a trip tot he hardware store to get something a bit more decent would be in order.

For now I need to know what size to get for the rad to support, water neck, A/C condenser to the rad support and which screws/bolts hold the shroud to the rad.  Rad and shroud are 26" out of a 70 ish C body but they're probably the same.  The dash screws can wait.  

[67tbird]

fastenal is a good resource if you aren't looking for exact copy

[ODZKing]

I know it is a bit tedious but what I've done in the past, like my hood bolts, is find the part number in the book then cross it to the chart.
Interestingly enough that is one of the few where it does not list an attaching bolt.
I can take one of mine out on the 67 (been meaning to anyway and clean them up) and take a pic but I can tell you they look like this.