Linkage Q's Please help

[69chargerdad]

Well I just purchased a new 750 Speed Demon carb with vacuum secondaries and an electric choke. When I switched the carb from the original carter avs along with other small problems the linkage was misaligned. Due to the different set up the linkage was shited nearly 2 inshes in. Does Demon Holley or anyone make a linkage kite to correct this problem? Or if anyone is running this set up on their 440 how did you correct this.

thanks once again

Marcus

[chargerbr549]

The part# is Holley 20-7, which I assume will work on your carb since its based off a holley design.

Kevin

[Chryco Psycho]

the Holley 20-7 works , you have to bend it a little & open the lower bolt hole up a bit to fit the Demon though 

[69chargerdad]

I took a look at the holley linkage piece 20-7 on there site and this just bolts on with two bolts to the main linkage arm and the original carter linkage stud is used in the remaining hole? Are these bolts and nuts included and does anyone have a picture? thanks again

Marcus

[Chryco Psycho]

yes the needed bolts are included , this is what you need , sorry I don`t have a pic handy

[Just 6T9 CHGR]

Is this it?

[Chryco Psycho]

Yes