Superbird Fender Scoop location???

[graybo]

Hi Guys, I just got my rear window trim, rear glass and fender scoops from Ted JANAK.  All look and fit awsome!!!(Thanks Ted).  Does anyone have the exact measurements to mount the fender scoops to the fenders?   Any help is much appreciated!   

[daytonalo]

Didn't know Janak was making stainless rear glass trim and tempered Backlite for Superbird ?

[graybo]

His rear trim is a composite (fiberglass??)  but it is one piece and will need to be glued in. It fits great and looks just like stainless trim.  I'm not sure what his rear glass is made of but it also fits great and is crystal clear. I don't think it is lexan. He again said it was a composite of some sort.   

[oldcarnut]

I had a drawing with measurements maybe even this pic posted somewhere but I seem to have misplaced a lot of it    Anyway maybe someone can give measurements for the letters or all the holes in the pic  
Found this post by moparstuart  http://www.dodgecharger.com/forum/index.php/topic,92718.0.html

"here are the measurement for where to place the scoopes on top of the fender

This is on my original fender with original scoops in the original holes
ok from the front of the fender to the front of the scoope is 25 1/2 inches
  on the out side of the scoope its 3/16 of an inch
on the inside towards the hood  the front of the scoope is 3/16
but the rear of the scoope is right on the fender edge at the hood
  Ok the rear of the scoope to the back point of the fender at the door is 23 3/4 inches


   

[nascarxx29]

The stainless superbird rear window original type trim is coming out

[FJ5WING]

If nobody is able to help you out I can give you the measurements in a few days.

[FJ5WING]

Do you still need measurements?

[oldcarnut]

If its not a lot of trouble can you post them what you have?
 

[A383Wing]

Janek should have given you the hole placement locations when you bought the scoops...he did with mine

hope yer parts are in better condition than mine were

[FJ5WING]

I need to revisit my measurements.

I just realized I measured the drivers side and want to be clear while using the posted picture for reference.

Sorry guys! I'll get you tomorrow.

[nascarxx29]

http://www.dodgecharger.com/forum/index.php/topic,92718.25.html

older post by moparstuart


Re: NEED MEASUREMENTS PLEASE superbird fender scoops studs

« Reply #18 on: October 09, 2012, 07:52:43 PM »

Quote


--------------------------------------------------------------------------------

here are the measurement for where to place the scoopes on top of the fender


This is on my original fender with original scoops in the original holes
ok from the front of the fender to the front of the scoope is 25 1/2 inches
  on the out side of the scoope its 3/16 of an inch
on the inside towards the hood  the front of the scoope is 3/16
but the rear of the scoope is right on the fender edge at the hood
  Ok the rear of the scoope to the back point of the fender at the door is 23 3/4 inches


    driver side  scoope inside and above

[DoubleDlover]

hey!! LOLOl That's my fender. LOLOl  I remember that pic. LOl Unfortunitly my fenders are up the in rafters right now. so I cant get to them to measure.. r

[FJ5WING]

Is anyone still looking for help or did Daves link resolve everything?

[graybo]

I got the scoop locations.  Thanks to all.  Much appreciated.   

[DonC1]

Good info!