Urgent cam help needed!

[CCR]

I have to decide what cam to use in my -68 Charger the next few days, going from Sweden to visit some friends in SF and really want the cam in my bag on the way back 

This is what I have so far

440 block bored .030 over
440 source stroker kit with 4.250" stroke 7.100" rod, pistons -17 dish (compression 10.3-10.5:1)
440 source heads, not ported will only do a bit of clean up.
Harland Sharp roller rockers 1.5 with heavy duty shafts
Holley Street Dominator intake
MSD Atomic EFI
TTI 1-7/8" headers 2,5" to the back with H-pipe

The car is for cruising only, not racing.

I want to go with a hydraulic roller cam (I know many of you are going to say  ) I have been looking at Crane cams, Howards, Comp Cams, Lunati and Hughes but can't make up my mind 

I will also need some help with convertor and stall rpm to match the cam. Talked to John Cope and he recommended a PTC 9.5" Street torque converter. I have 3.23 rear end.