Where did you run wire for a/f meter in car?

[70sixpkrt]

I have an Innovative LM1 A/F device and I want to run the cable in the car instead of outside the door thru the window. What I want to know from guys that are running this device is where did you route the cable. Did you drill a whole thru the floor board and feed the cable thru it? I kind of don't want to drill a hole. I am trying to find an existing whole in the fire wall or floor board. Eventually I will be buying an AEM gauge and mounting it permanently.

[flyinlow]

Not familiar with the LM 1 . I do have an AEM analog on my 3rd gen. The plug that goes into the back of the gauge is the smallest plug that you will have to route thru the firewall. about 3/4' across if I remember. if you wanted to spice all those small wires you could get down to about 5/16" i drilled a hole near the steering column.

The sensor in the exhaust should be pointed down at the tip so it does not trap moisture.