need answers about PG Classic part

[bobfist]

Hi!

I need a new 1969 Charger Super Bee GTX RR Rallye Gauge Bezel the plack complete panel for my 69 rt.
I also had the wood grain panels in my car.
My question are if someone has buyed this from pg classics?

The wood grain panels are installed with the small tabs at the back onto the black panel but i cant see any holes on their black panels

Do i have to make those holes in their black panels myself?

Any one knows anything about this?

[bill440rt]

I have heard also that the holes need to be created for the tabs to go through.

[fy469rtse]

I'm sure they make them with the holes for wood grain, give them a call, might be a simple exchange, I re did my old dash fascia but bought the rest and sure they had the tab holes in them

[strokie]

#7 




strokie



StatusOnline Junior Member
--------------------------------------------------------------------------------
Join Date:Mar 2013Location:quebecPosts:4Thanks:0Thanked 3 Times in 2 Posts
View photos by strokie
Trader Score:0






  :flame:Bad experience with P G Classic Charger Dash Gauge Bezel....
I hope B/E&A don't have the same source for those bezel !
Recently I bought 144-66CH -1966-67 Charger Dash Gauge
Bezel Non/AC

I must say the cosmetic of the part is good,but the fit of the part is not,

After installation of the new Dash Gauge Bezel I realise
the part was not fit deep enough in the dash,  I tried to figure out what was the problems (remove and
install many times the bezel) and I do dammage to the bezel ,many
scratches...

After inspection I found the problem, the back of the
bezel is not like the original more material in the back .

To fit the bezel I do a lot of rework on the metal
housing to have a decent fit...

Now the fit is better but the bezel is damage.If the part fit the first time I will not end
with many scratches and dents.


I sended Email to P G Classic never had an answer, 

PG= poor chinesse repro bezel...