426 Hemi engine wiring harness

[hemi68charger]

Hey gang..

Curious.. I just got my engine harness for my 426 Hemi, application 1969 Dodge Charger Daytona. Well, I laid it out over the motor/valve cover and noticed there wasn't a connection for the oil pressure sending unit... Is it different on a hemi car or did M&H just mess up?

Cheers,
Troy

[Charger-Bodie]

Oil pressure wire is in the battery cable on a HEMI.

[hemi68charger]

Oil pressure wire is in the battery cable on a HEMI.

Yeap, after another reply on another board, I went to the garage and looked at my new positive cable,... Sure enough, there it was.............  Weird, but that's the way MaMopar did it nonetheless.......

[Charger-Bodie]

Oil pressure wire is in the battery cable on a HEMI.

Yeap, after another reply on another board, I went to the garage and looked at my new positive cable,... Sure enough, there it was.............  Weird, but that's the way MaMopar did it nonetheless.......

What? My response wasn't good snuff for ya?

[hemi68charger]

Oil pressure wire is in the battery cable on a HEMI.

Yeap, after another reply on another board, I went to the garage and looked at my new positive cable,... Sure enough, there it was.............  Weird, but that's the way MaMopar did it nonetheless.......

What? My response wasn't good snuff for ya?

No, the other response on the other board came first,  by a few minutes..... I wasn't "verifying" yours.......  Right before I read your reply, I had just come from the garage to look at my positive cable...   

[Charger-Bodie]

Troy , You have tti218 headers? Right? If so,do you plan to use gaskets? When I did mine in the Daytona clone I only used high temp silicone as per Tim at FHO. sealed perfect and it brings the headers that very small amount closer to the block and away from things like steering box. I just installed the used ones I got the other night in the same fashion.

[hemi68charger]

Troy , You have tti218 headers? Right? If so,do you plan to use gaskets? When I did mine in the Daytona clone I only used high temp silicone as per Tim at FHO. sealed perfect and it brings the headers that very small amount closer to the block and away from things like steering box. I just installed the used ones I got the other night in the same fashion.

Yeap, I have tti218 headers. As far as using the gaskets, I had planned on it. Seriously, never thought about only using the high temp silicone.. Not that I don't want to, just never entered my mind.........