Tail light wiring harness ?

[Daytona R/T SE]

The tail light wiring harness for a '69 Charger that M&H makes and sells through Year one and Classic industries...

Does it include the wiring for the license plate light, backup lights and the fuel tank sending unit?

[Hard Charger]

it does
I just installed one.
it appears to be a universal one for this generation. I found a couple of the leads to be a little longer than I needed.

[Daytona R/T SE]

it does
I just installed one.
it appears to be a universal one for this generation. I found a couple of the leads to be a little longer than I needed.

Ok thanks.

I guess too long is better than too short.

Can you post any pictures?

[Hard Charger]

i just delivered the car back to the painter for the final assembly of the panels.

i would be happy to when it comes back, it could be 2 weeks.

i believe it was the lead to the license plate and the gas sending unit that were long. also i also remember there was a rubber grommet on the license plate lead where my original did not have or it was the wrong size...its been almost a year since i installed it.

i was very happy with the quality of the harness and have bought many for all my cars.

[Daytona R/T SE]

Does it have the grommet for where the wire goes through the trunk floor to the gas tank sending unit?

And it does have the back up light wiring too, correct?

[John L]

Does it have the grommet for where the wire goes through the trunk floor to the gas tank sending unit?

And it does have the back up light wiring too, correct?

I put one in my 70 just 2 months ago. Yes it does have the grommet for the sending unit, the license plate and BU light wires are there also. It took just about an hour to put in but I already had the back seat out and bumper off.HTH

John

[Daytona R/T SE]

OK, Thanks guys.

That's what I needed to know...

[Hard Charger]

Does it have the grommet for where the wire goes through the trunk floor to the gas tank sending unit?

And it does have the back up light wiring too, correct?

yes on the grommet

yes the back up light length was ok if I remember right. (being in the tail light bezel and not the valance.)