News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Aftermarket air conditioning installation

Started by Highbanked Hauler, October 10, 2013, 04:55:33 PM

Previous topic - Next topic

A383Wing

yes..all the under hood stuff will be needed as well...but if you could find the original stuff, that would work....

in the search above, there is a complete kit there for $500...you would have to figure out mounting bracket for compressor. All switches are in the under dash unit

here is another search for evaporator units...just to show you what's out there


http://www.ebay.com/sch/i.html?_trksid=p4634.m570.l1311.R1.TR2.TRC1.A0.Xunderdash+ac&_nkw=under+dash+ac&_sacat=0&_from=R40

twodko

FLY NAVY/Marine Corps or take the bus!

shart70rt

Just starting installing mine in a 70 Charger RT. The AC/heater box is installed under the dash. Template they supplied for cutting holes was not very close and I had to expand the holes, I should have checked that before I cut. Will have to clean that up with seam sealer and use touch up paint when complete. I will also make an extra bracket for support of the tail end of the unit. don't like that it bounces a bit.

I will take some pictures in the next few days. Finally putting the car back together, but only get 5 or 6 hours a week.

Have had the kit for 6 or 7 years, but it has just been sitting.

Like a previous poster, bought mine without the compressor. Installed the serpentine system from Billet Specialties, and they supplied high output alternator, power steering pump, and Sanden AC compressor. That system is absolutely gorgeous. I will post a picture of it also.

Will be installing relays for all high pull accessories, and doing the recommended wiring changes before starting up.

Bought a Be Cool modular system to go in it also, so should cool. All this stuff was bought over the last 8 years. Will need it to cool the Stroker on the Texas Gulf.Coast.

Stephen

Stephen
Stephen Hart
1970 Charger RT, 440, console 4-speed, Dana 60 3.54
500 Stroker, Edelbrock Heads, Edelbrock intake, dual 600 CFM Carbs,
Comp Hydraulic Roller
Centerforce Dual Friction Clutch setup, Passon Performance overdrive gearset in 833 18 spline 4 spd.
TTI 2 inch headers and 3 inch exhaust.
Subframe connectors
P-S-T polygraphite suspension
4 wheel disc brakes
Classic Auto Air AC
Billet Performance Serpentine Assy
reassembly in progress