Am I missing a bracket for a Superbird seal?

[Hoser2455]

While putting together my car, the shop that is doing my car questioned me if I had any brackets that go on the lower front panels behind the nosecone on my Superbird.  They said that Coronets had these brackets but wondered if mine gets them or not.  These would be brackets that go in front of the seal by these panels.  Do Superbirds get these brackets, or does the seal flap in the wind?  Enclosed are some pictures of what I am talking about.  If I do need any brackets, anybody have any?

Thanks, Jeff

[pettybird]

You're good.  It'll make a lot more sense when you install the lower valance panels.

[Hoser2455]

Still a little confused.  I haven't been back to the shop to put them on yet.  Does anything hold this seal down or retain it, or does it just kind of hang there?

[nascarxx29]

  :Twocents:One of the seals for the k frame has the speedometer clips holding the seal to the straight brackets.Then the small square seal slips over the lower center of rad support
http://www.dodgecharger.com/forum/index.php/topic,76053.0.html

[pettybird]

Still a little confused.  I haven't been back to the shop to put them on yet.  Does anything hold this seal down or retain it, or does it just kind of hang there?

It just hangs, though it gets wedged in by the lower panels. 

[pettybird]

 :Twocents:One of the seals for the k frame has the speedometer clips holding the seal to the straight brackets.Then the small square seal slips over the lower center of rad support
http://www.dodgecharger.com/forum/index.php/topic,76053.0.html

That is the lower rad to K frame seal.  These are the fender to valance seals.  These are not meant to be removable once installed.

[hotrod98]

There won't be any wind there once you install your valance.

[Hoser2455]

Ok, thanks for the info guys!