Rear window defroster

[John L]

All,
I'm trying to replace my missing rear window defroster. The car is relatively new to me and it was missing. I was able to track down all the parts and got them installed.

I need to figure out where the 12v supply comes in to tie into the switch. In the FSM it is circuit C10-18LGN and tells me to "see accessory wiring diagram". In my manual I can only find the Accessory Wiring Diagram for a Coronet. The dash harness has been replaced and I can find no way to hook up the LGN bullet connector from the switch harness to the dash harness. Not sure if M&H wires their dash harnesses for this option or I am just missing something. Any help would be appreciated.

[Ghoste]

What year?

[John L]

Sorry bout dat  70 Charger

[ChargerST]

Isn't 1970 the first year for the two speed blower motor (resistor looks like a heater coil and is inside the blower housing)?

[Brock Lee]

I believe it runs from the switch to the appropriate fuse at the fuseblock and connects with one of those piggyback connectors.

[John L]

I believe it runs from the switch to the appropriate fuse at the fuseblock and connects with one of those piggyback connectors.

Brock,
  There is a male bullet connector on the light green wire coming from the switch harness. The connector sure looks factory as it has the sealed rubber around it. From the service manual I would agree with you as no bullet connector is shown on the schematic. This is what has me so puzzled (very easy thing for me).

[John L]

ok after 45 minutes on the phone with Ken from M&H we both gave up. If anyone here has the optional rear window defroster and can tell me where the 12v feed comes from I would greatly appreciate it.

John

[nascarxx29]

http://www.dodgecharger.com/forum/index.php/topic,5532.msg64721/topicseen.html#msg64721