quarter panel patch

[Ryan.C]

anybody use the quarter panel patch(now discontinued) from AMD?
I only need the lower section below the body line under the marker light and a small section of the wheel opening.

I was going to fab my own patch but the wheel opening has me a little nervous since I am no metal fab pro. any suggestions?

[nvrbdn]

what side?

[tan top]

I used these quarters or ones like these & just used the lower rears under the green stripe ,  cant remember if they come from yearone or route 66  autobody   was so long ago  , this was long before AMD came out  , think it was yearone though ,  will check recipts

https://www.yearone.com/Product/1966-74-a-b-e-body/mr893lhrh

[nvrbdn]

i believe i have both sides sitting in the garage waiting for a need.

[Dino]

Don't worry about the wheel opening too much.  Worry about the straight part.  It has to line up perfectly because if the curvature of the patch is different from the curvature of the quarter, it will buckle and warp.  And then there's welding that 90 feet of steel....

[six-tee-nine]

Are these AMD patch panel discontinued?

I need those too so if they are  I might need to urgently buy a set somewhere.........

[Ryan.C]

thanks for the replies guys. and yes they are discontinued as per the AMD rep I spoke to this morning. But luckily some of the vendors have them in stock.

[tsmithae]

I have the right side brand new from AMD if you need it. It is for a '70 but if all you need is below the marker light, it would work perfectly. 

[six-tee-nine]

hah no sorry, need the upper rear part as wel since the corner by the taillight panel is dented thanks for the offer...

[Dino]

hah no sorry, need the upper rear part as wel since the corner by the taillight panel is dented thanks for the offer...

Is the dent that bad?  There's pretty good access to that corner.

[Ryan.C]

http://www.autobodyspecialt.com/cgi-bin/commerce.cgi?search=action&category=0007

FYI-these guys have a bunch of these AMD patches in stock for $75.00 each. I just bought both sides.

[nvrbdn]

sorry for the delay of geting back to you. i was on the road headed home. anyway, since you have them ordered i will just keep them.

[six-tee-nine]

hah no sorry, need the upper rear part as wel since the corner by the taillight panel is dented thanks for the offer...

Is the dent that bad?  There's pretty good access to that corner.

Well THE car took a hit on the rear bumper, wich slammed in THE quarters. I need to replace both lower pieces so with these AMD parts i can replace the dented parts as well.

Thanks for the link Ryan Will order this weekend.

[Nacho-RT74]

thanks for the replies guys. and yes they are discontinued as per the AMD rep I spoke to this morning. But luckily some of the vendors have them in stock.

nice! now I can't stop to dream about getting more 3rd gen parts. It seems will have to change to an A body