window rivet question

[flathead1946]

I am attempting to put the windows in my 1968 charger, and am missing some parts. I know I need the plastic rivets for mounting the door glass to the regulator but don't know what I need for mounting the quater windows to the window track. What does the bolts/rivet look like and wher can I get them. thanks

[fy469rtse]

the rears are a bolt, large thin washers to head in two places,did you bag and tag when you pulled the out, if not i would go to your manual, the glass is insulated with washers plastic from memory  mine were decayed , but they should be plastic or you could use a thin rubber washer to each side of glass , be careful not over tighten bolts , just snug , i think I saw repops at charger specialtys or rt specialtys

[tan top]

     , also there are little sections of  OEM  rubber radiator over flow hose  , from the factory , slid on the bolts that go through the glass , few thousants  longer than the thickness , of the glass , so when the  bolt it tightened , it compresses & grips the glass tight , and takes up any clearence ,

heres picture od bolts , not sure where i saved the picture from , might of been on here 

[fy469rtse]

just saw the rubber insulators , look for resto ricks site

[tan top]

just saw the rubber insulators , look for resto ricks site

 thats them

http://www.restorick.com/proddetail.asp?prod=Glass544

actually having a flash back now ,  think its not a section of the radiator over flow hose , but the factory used sections of the  large vacuum hose that goes from the intake vacuum tree to the vacuum canister ,
anyways on the original ones you can see the three ribbed design same as over flow or vacuum hose , i lost one of mine  , & had to make a new one , cant remember what one i used !!  , but what ever one i used !!  it was it was exact match