rear brake hydraulic tee

[hemi68charger]

Hey gang.
Ok, this isn't my first rodeo, but something doesn't seem right. I have 3 hoses for the rear and all have the same thread count. But, the hose bottoms out. I could have swore the hose should bottom out with one of the brake line washers. My B-bodies do. The inside is your typical flare fitting, so that parts correct. Anywho, I was hoping to get the hydrualics of this '71 Challenger wrapped up tomorrow. I just bench bleed the new master cylinder....

[kab69440]

As long as it's seated and doesn't leak, I don't see why it won't work.

[Chryco Psycho]

the fitting for the hose should be a flare fitting too & the end of the hose should be reverse flare so ti will seal without a washer