68 dash removal

[Evolution69]

Hi guys any tips, write ups on removing the dash from my 68?
I did do a search and I came across a thread about a 69, I read that the windshield had to be taken off first, is this true?
In that case any tips, for removing the front windshield as well?

Thank you for your time.

[tan top]

have  a read here ,
http://www.dodgecharger.com/forum/index.php/topic,100417.msg1178403.html

as for  the windshield  , same as a 69 , needs coming out , remove stainless trim ,   if its an old original gasket best to cut the rubber gasket to get the glass out ,( with a sharp knife run round  just to the out side of the locking strip , )) the original rubber gasket cant really be reused , as its gone hard with age ,  

(((((there is away to get the glass out with the original rubber intact , & or a rubber thats recent & in good supple condition  , with out cracking the glass ,  but it takes along time , & reqires putting out ward pressure to a corner of the glass to start with , with the plam of your hand / foot , after the gasket locking strip has been un done ,  then with a push stick or bondo spreader & liberal squirt of WD40 on the rubber push the gasket lip around tha glass , with continued pressure on glass ,  only do this if you know what your doing & use to dealing with windshields etc other wise your crack the glass quicker than you can say , i need a new windshield    !!!)))

like i say  no real point cause your going to put a new gasket in anyway  , just cut the rubber ,
( but i done it this way &  saved the original gasket , even to throw it away later   , cause i'm nutts like that for doing stuff there is no real need to do  

[Evolution69]

Thanks Mr Tan Top,  I shall try the first method this weekend, I can see a line in the windshield not sure if its a crack, will take better look tomorrow, but thanks for the info you helped me out a lot.
Kind regards.